Why is Netgear R8000 AC3200 Dropping Device Connections?

Netgear R8000 AC3200 Dropping Device Connections

Are the devices connected to your Netgear R8000 AC3200 router dropping internet connections every now and then? Well, that might be happening because of excessive load. When the network traffic is high, devices fail to work optimally and fetch a stable internet connection. Therefore, disconnect a device or two from the router’s WiFi network will do some favor. However, if still Netgear R8000 AC3200 dropping device connections, here’s what you need to do.

Solved: Netgear R8000 AC3200 Dropping Device Connections

Let us now find out why devices connected to the WiFi network of the Netgear router drop the connection and what you can do in order to fix the problem.

1. Update the Firmware

When the firmware of a device gets outdated, its starts behaving weirdly. There are high chances that the devices on your router’s network are dropping the internet connection because the firmware is not updated. Therefore, upgrade the firmware of your AC3200 router via the router login IP. It is very similar to performing Netgear extender firmware update via You can also use the Nighthawk app to upgrade the firmware.

2. Restart the Router

Sometimes, network errors are the reasons due to which connected devices drop connections. You are advised to get rid of them as soon as possible. For this, simply restart the router. The process is not very difficult. You are just required to unplug the AC3200 router from its respective power outlet and wait for a few moments. Once done, you can switch on the router and verify if the devices on its WiFi network are still losing connection.

3. Remove WiFi Interference

WiFi interference present around the router can be another reason why the Netgear R8000 AC3200 dropping device connections. You are advised to check the surroundings of the router. See whether the AC3200 is surrounded by devices emitting electromagnetic radiations. To be specific, verify if there are any televisions, microwave ovens, refrigerators, washing machines, etc. present near your router. If yes, you should change the R8000 location right away. Also, ensure that the router is not placed very close to a mirror or a fish tank.

4. Check LAN Connections

Although this is a very distant reason, still it is recommended that you observe all the LAN connections related to the AC3200 router. First of all, see the cable linked to the router and modem. Is it damaged? If it is, then you should get it replaced with a new one. Apart from this, be very sure that the connection between the R8000 router and the modem is finger-tight. The same thing applies to other Ethernet cables involved in the network system.

Check LAN Cables

5. Inspect Geofilter Settings

Log in to your WiFi router and verify if the Geofilter is on. This is to inform you that when the filter is on, the devices present outside a certain range get poor or no WiFi connection. The possibility is that the devices you are using fall outside the Geofilter location. Therefore, you are suggested to adjust the Geofilter settings.

This is how you can take a few steps if the Netgear R8000 AC3200 dropping device connections. If nothing happens, then we recommend you extend its network range by performing Netgear extender setup. The extender will send signals even in WiFi dead zones and that too without connection drop.

The Final Words

Here, we are ending our guide explaining what to if the Netgear R8000 AC3200 dropping device connections issue shows up. We are being hopeful that the problem we discussed in the write-up is not troubling you. Just in case, the problem is still there, reset your R8000 and set it up once again.